Adding a jackplate

[tmlrock2001]

I have a 482 with dual cable steering and want to add a jackplate. My questions are

1. Will my cables be long enough to add a 6" plate and will I have to drill different holes to change the angle of the cables or can I run them directly?

2. If the cables are too short or if the angle is too bad can I add a 4" without any problems?

3. Also I am going with manual (cost) so which brand do you guys recommend? I would like one that you can change on the water

[BassBUFF]

The cables usually aren't long enough, but take some careful measurements to be sure. Don't know if I'd go to the expense of a hydraulic unit on that boat, but to each his own. I've never played with that model either so hopefully someone more informed can give you a recommendation on setback.