save your senkos

fishmagnet · January 23, 2008, 06:14:27 PM

You can use a soldering iron to melt the plastic where your hook tears them. do it in a well ventilated area though cause the fumes are nasty.works on most plastics. i wrapped a paper clip around the hot piece leaving about 1/2 inch needle so it wouldnt ruin my solder gun.

MotherNature · January 23, 2008, 06:32:46 PM

That's a great idea fishmagnet...

BIG PAPA · January 23, 2008, 09:34:36 PM

Good idea, thanks

BlackStrat · January 28, 2008, 08:03:51 AM

That is a really good idea! I have a lot of plastics laying around torn...I will try this!

Thanks again!

Bassman50 · January 28, 2008, 05:28:59 PM

Quote from: fishmagnet on January 23, 2008, 06:14:27 PM
You can use a soldering iron to melt the plastic where your hook tears them. do it in a well ventilated area though cause the fumes are nasty.works on most plastics. i wrapped a paper clip around the hot piece leaving about 1/2 inch needle so it wouldnt ruin my solder gun.

Bassman50 · January 28, 2008, 05:29:32 PM

cool

HellaBass · January 28, 2008, 09:01:14 PM

You could just get a bottle of Mend-It as well

bigjim5589 · January 28, 2008, 10:49:33 PM

Pro's Soft Bait Glue works also.