I need this tip on pour plastic

[pakrat846]

I was thinking of buying a creature bait mold and this is my question.  I am wanting to pour baby brush hogs so where would I start the pour on this mold to make sure the tail and little arms get filled before the plastic runs out of the mold cavity? I know it has to be tricky to get a good pour.Thanks PAK.

[Bountiful Waters]

Each mold is different. It will only take you a couple of tries to figure out which way works best. If you mess up, just re-melt. One peice lizard molds are always a pain, much like some creature molds.

Do a search on tackle Underground for Brush Hog pours.