First time boat owner Nitro 750

Bud Kennedy · October 12, 2018, 06:47:57 PM

OK thanks for the prop info. The number helps a bit but fyi it should also be stamped on the end of the hub where the prop attaches to the shaft. I don't think we need to know more about the prop unless someone knows the manufacturer of the prop.

I think you need to take a deep breath for a bit and get the motor raised to the correct height and find out how the boat performs then the next steps can be taken. If you go one step at a time it will avoid a lot of confusion down the road.

Bud Kennedy · October 12, 2018, 07:15:17 PM

By the way your prop is a Quicksilver Laser II

it is 13.5 x 24

Probably a good selection for your 115 hp Merc

Burbarry · October 12, 2018, 11:57:00 PM

Yeah it is a laser 2 I should have posted that picture as well or mentioned that. But my first step was going to be raise motor up.

Sent from my iPhone using Tapatalk

Ron Fogelson · October 13, 2018, 02:23:16 AM

The smaller nitros come rigged with aluminum props, they flex so much more then SS it isn't even funny that's why you see the boat / motor rigged lower. The tracker motor I believe is a force but in2005 they may have been shut/shutting done by then and rebadged a merc I just don't remember.

As far as moving the motor if you have an engine hoist or crane you can do it your self. Good luck, great looking boat congratulations

Burbarry · October 13, 2018, 06:39:41 PM

So looking at this is it really as simple as using the hoist move up one notch? Will I need to unhook anything or should it be ok just lifting it?

Sent from my iPhone using Tapatalk

Ron Fogelson · October 13, 2018, 06:54:26 PM

4 bolts is it, lift and rebolt

Make sure the lift is firmly attached and ready to go before unbolting

Bud Kennedy · October 13, 2018, 07:25:24 PM

Yep thats about it. Be sure to be aware of the fuel line and steering cables. You don't want to put them in a bind but usually that is not a problem. If you feel it may they are both easy to disconnect from the motor.

Oldfart9999 · October 14, 2018, 11:34:18 AM

Put either silicone sealer or 5200 adhesive around the bolts before you tighten them, you transom will thank you with many years of no rot.
Nice looking boat!!!
Rodney