Print Page - Recarpeting sealed wood question??

Title: Recarpeting sealed wood question??
Post by: Top-Water on March 13, 2012, 07:42:23 PM

After applying 4 coats of spar varnish to plywood I'm worried that the glue will not adhear to the surface. Has anyone used Cabots marine durability spar varnish before and then carpeted over it? If so what were the results? I knew I had to seal the wood and while shopping for a good product the "marine durability" on the can jumped out at me so I rolled with it. Now I am thinking it may have been a mistake... This stuff seems like it's only for surface stuff. It's like glass. Please help!!

Title: Re: Recarpeting sealed wood question??
Post by: PD Fisher on March 13, 2012, 08:42:18 PM

I would lightly sand the surface area you want to glue on with 80 grit paper. All you are looking for is roughing up the area so the glue will stick. 80 grit doesn't have a lot of bite so the wood will still have the protection of the varnish

Please do not use Outdoor Hub Mobile, Please find and use TapaTalk for your phone

Title: Re: Recarpeting sealed wood question??
Post by: Top-Water on March 15, 2012, 11:00:24 AM

Thanks!!

Title: Re: Recarpeting sealed wood question??
Post by: coldfront on March 15, 2012, 11:45:13 AM

Quote from: PD Fisher on March 13, 2012, 08:42:18 PM
I would lightly sand the surface area you want to glue on with 80 grit paper. All you are looking for is roughing up the area so the glue will stick. 80 grit doesn't have a lot of bite so the wood will still have the protection of the varnish

4 coats of spar varnish...should be 'some' thickness there...

Title: Re: Recarpeting sealed wood question??
Post by: Top-Water on March 15, 2012, 08:09:18 PM

I'll tell ya what.... It's not that bad.

Bass Fishing Forum

General Bass Boat Discussion => Aluminum/Jon/Semi-V Bass Boats => Topic started by: Top-Water on March 13, 2012, 07:42:23 PM